/* esempio_5_test_display * test del display sullo shield arduino. * accende per 250mS ogni segmento ed il punto * * Connessioni dello shield e * * Digital 2 - In Tasto S3 * Digital 4 [3] - Out Segmento e * Digital 3 [4]4 - In Tasto S2 * Digital 5 - Out Segmento d * Digital 6 - Out Segmento c * Digital 7 - Out dp - Punto Decimale * Digital 8 - In Tasto S1 * Digital 9 - Out Segmento b * Digital 10 - Out Segmento a * Digital 11 - Out Segmento f * Digital 12 - Out Segmento g * Analog 0 - Fotoresistenza - Luce * Analog 1 - NTC - Temperatura * --a-- * | | * f b * | | * --g-- * | | * e c * | | * --d-- dp */ #define LEDPIN 13 #define APIN 10 #define BPIN 9 #define CPIN 6 #define DPIN 5 #define EPIN 4 /* 3 */ #define FPIN 11 #define GPIN 12 #define DPPIN 7 #define S1PIN 8 #define S2PIN 3 /* 4 */ #define S3PIN 2 #define LUCE 1 #define TEMP 0 #define NUMSEGS 8 /* Array dei numeri di piedino, per ogni segmento del display */ char segments [] = { APIN, BPIN, CPIN, DPIN, EPIN, FPIN, GPIN, DPPIN }; void setup () { int i; for (i = 0; i < NUMSEGS; i++) { pinMode(segments [i], OUTPUT); // Imposta il piedino del segmento a in uscita digitalWrite(segments [i], HIGH); // Spegne il LED } } void loop () { int i; for (i = 0; i < NUMSEGS; i++) { digitalWrite(segments [i], LOW); // Accende il LED delay (250); // Attende 1/4 di secondo digitalWrite(segments [i], HIGH); // Spegne il LED } }